Licensed and Insured Independent Pros
Extraction contractors we refer are independent local businesses that carry their own license and insurance. Ask at the door if you want to see the paperwork; good crews keep it in the truck.
If water beads up when you press on the carpet, the pad underneath is soaked and evaporation alone will be painfully slow. Real extraction gear pulls water out of carpet, pad and floor seams far faster than any fan can dry it.
Our referral line connects Arnold Line callers with independent, licensed and insured contractors who run truck-mounted and portable extractors. You get a written quote before the extraction wand ever hits the carpet.

Extraction is a pure equipment job: the power of the machine and the right tool head decide how much water comes out.
Extraction contractors we refer are independent local businesses that carry their own license and insurance. Ask at the door if you want to see the paperwork; good crews keep it in the truck.
The estimate spells out square footage extracted, pad removal if needed and any equipment left behind. Many contractors bill the insurer directly once you have a claim number.
Wet pad starts to sour within a day or two, so speed matters more here than almost anywhere. Our dispatcher confirms a real arrival window with a crew near Arnold Line while you are on the phone.
Expect a truck-mounted extractor with serious vacuum lift, and portable units for upper floors and apartments. Stand-on and weighted tools press body weight into the carpet so the pad gives up its water, not only the top fibers.
Each gallon removed by the extractor is a gallon that never has to be evaporated and captured by a dehumidifier. Extraction removes water in liquid form, which is many times faster than turning it into vapor with air movers. Skip that step and the drying phase drags on for days longer than it needs to.
A wet vac works on the surface fibers and has nowhere near the suction of a truck-mounted unit. It also cannot reach the pad, which is where most of the water sits. Folks run one all evening and still end up with carpet that squishes.
Take a refrigerator ice-maker line that leaked into wall-to-wall carpet overnight. That is clean water, so the crew may float the carpet: lift it off the tack strip, pull the soaked pad, extract the carpet in place and set drying underneath it.
Laminate is a tougher case: when water runs under the planks in a rental unit, it sits in the underlayment where you cannot see it. Meters and specialty mats show how far it spread, and any planks with swollen edges usually have to come up.
Rule of thumb from the field: carpet in clean water can often be saved, but the pad underneath is usually thrown out and replaced. Pad is cheap; carpet is not.
Time matters too: clean water left sitting for days in a warm house picks up bacteria, which shrinks the list of what can be saved. That is one more reason to get the extractor in early.

Carpet, wood, laminate and upholstery all trap water in their own way, which is why the tool heads change room to room.

Slow, overlapping passes with a weighted head continue until the clear wand shows almost no water. Wet pad is usually cut out and bagged, then the carpet is relaid once dry.
For a clean-water leak, the crew can pull the carpet off the tack strip, slide air underneath and dry it in place. This saves the carpet and keeps it out of the dumpster.
Flat panels sealed to the floor pull water up through the seams and out of the boards under vacuum. Caught early, this can keep solid hardwood from cupping badly.
Water slips under click-lock planks and sits on the subfloor where you cannot see it. The crew maps the wet area with a meter, lifts planks where needed and extracts the subfloor below.
Sofas, chairs and rugs get extracted with smaller hand tools sized for fabric. Wool and handmade rugs usually get sent to a rug cleaning plant for full washing.
Once the water is out, the tech maps moisture across the floor and along the base of the walls. Those readings tell the crew where the drying equipment should go.
Let the dispatcher know the flooring type, the size of the wet area and the source of the leak. We route you to the nearest independent extraction crew and give you an arrival window.
The crew pulls up with a truck mount or portable extractor, wands, weighted tools and moisture meters.
First the tech identifies the water source and category, measures the wet area and decides what stays, then puts the quote in writing.
When the extraction is finished, you see the final readings, the drying setup and what was removed before you sign off.

The fridge ice-maker line let go overnight and the living room carpet was wet from the kitchen to the far wall. The contractor I was connected with pulled the pad, extracted the carpet with a stand-on tool and saved the carpet itself. No smell afterward, which I was worried about.
Water from the hall closet in my apartment ran under the laminate before I noticed. The crew my landlord and I were connected with found it with a meter, pulled the wet planks and extracted the subfloor.
I spent three hours with my shop vac and the carpet still squished. The extractor the contractor brought pulled more water in a few minutes than I got in an evening.
The washer drain hose came loose and water ran under the hallway hardwood while we were at work. The contractor we reached through the referral line laid suction mats over the boards and ran them for most of the day. The floor cupped a little and then flattened back out as it dried.
Often, if it got wet from a clean source like a supply line or ice-maker and is extracted quickly. The pad below is normally thrown out, since it traps water and smell.
If sewage or floodwater soaked it, the carpet generally has to go.
Wet vacs grab surface water but lack the suction to pull water out of the pad. Most of the water sits in the pad and subfloor, which a wet vac cannot reach.
Pros use weighted tools that press water out of the pad while the extractor pulls it away.
Extraction itself often takes a few hours for a typical room or two. Drying afterward is a separate step that can take several days.
After checking the size of the wet area, the crew can tell you how long it should take.
It should not, as long as the wet pad comes out and the carpet is dried fast. A smell usually means water stayed in the pad or subfloor for too long.
You can ask the crew if an antimicrobial treatment makes sense for your floor.
Extraction is the vacuum step that removes liquid water from carpet, pad and flooring. Drying comes next, using dehumidifiers and air movers to remove the moisture that is left.
Good extraction makes drying much shorter.
The extraction contractors we refer are local, so the truck mount is not hours away.
For upper-floor apartments and condos, crews bring portable units since a truck hose will not reach. Houses and small storefronts usually get a truck mount parked right outside.

A dispatcher will route you to a nearby extraction crew.
Call +1-877-637-9008Quick extraction saves carpet and shortens drying. Call now to reach a local crew.