Licensed and Insured Independent Pros
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
Once the drying gear is hauled out, most homes are left with open walls, bare subfloor and missing trim. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Brookside homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. You get a written, line-itemed scope before anyone picks up a hammer.

Restoration is drywall, trim and flooring work done on a house that just got soaked. The contractors we refer around Brookside handle both the carpentry and the paperwork.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many contractors use the same line-item format adjusters work in, so the claim review moves faster.
Restoration is not usually a midnight job, yet a slow bid can hold up your entire claim. Our dispatchers confirm a real walkthrough time on the call with a contractor who works near Brookside.
Rebuild crews carry texture hoppers, knockdown knives, trim saws and coping saws, not air movers. That kit, plus a steady hand, is what keeps a repaired wall from looking patched.
The work follows the scope of loss, which lists each material removed during the dry-out that now has to be replaced.

Flood cuts get closed with new board, then tape, three coats of mud and sanding. The hard part is texture: orange peel, knockdown and skip trowel all have to blend into the wall that stayed.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
The crew cuts a small chip from a dry wall and has the paint store scan it for a match. Good contractors repaint the affected walls corner to corner, so there is no halo around the repair.
Contents can be boxed, listed and stored off-site so the crew has open rooms to work in. The itemized list doubles as proof for the contents portion of the claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. Adjusters move faster when the paperwork answers their questions before they ask them.
Mitigation is the emergency half: stop the water, extract it, tear out what cannot be dried and run equipment until the readings hit dry standard. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Take a dishwasher supply line that dripped under the cabinets for days before anyone noticed. The dry-out crew pulls the toe-kicks, drills or opens the cabinet bases and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or think about an upstairs toilet that overflowed and rained down through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Plenty of companies only do the dry-out. Ask any contractor directly whether the rebuild is included, and make sure the answer is in the written scope.

The process has four steps, and the first is a short phone call.
Tell the dispatcher what was removed during mitigation and whether you have an open claim. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
At the end you walk every room with the contractor and write down anything that does not look right. Sign off only after the punch list is cleared, and ask for any workmanship warranty in writing.

The dishwasher line had been leaking for who knows how long. The dry-out company left us with no toe-kicks and a sink base that looked like a sponge. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Our kids clogged the upstairs toilet, it overflowed, and the kitchen ceiling ended up with a hole the size of a door. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I was sure the oak floor in our hallway was a total loss. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. It looks better than it did before the leak.
I own a duplex and the tenant was living out of two rooms while the rest sat gutted. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. The delays usually come from backordered materials and claim approvals rather than the actual work.
Ask your contractor for a written schedule with the order of trades.
Generally you can. Your carrier may recommend a preferred vendor, but most policies let you hire the contractor you pick. Read your policy and confirm with your adjuster before signing anything.
A lot of the independent contractors we refer deal with adjusters every week and write estimates the way carriers like them.
Often, if they are solid hardwood and were dried quickly. Mild cupping can settle once the moisture content comes back to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Engineered flooring and boards that crowned, split or buckled usually need replacing.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. Paint is matched from a chip of the existing wall, not from a guess at the color name.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The contractors we refer live and work in the area, so they know the local housing stock and the local permit office.
Older homes near downtown Brookside tend to have plaster walls and solid wood trim that take extra care to match. Newer subdivisions mean builder-grade drywall, MDF base and LVP that are easier to source but quick to swell.

Tell us what came out and we will connect you with a local contractor.
Call +1-877-637-9008