The water is gone and the fans have been picked up, but the kitchen still has a two-foot flood cut and no baseboards. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Bear homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. You get a written, line-itemed scope before anyone picks up a hammer.
A rebuild after water damage is finish carpentry with an insurance file attached. The contractors we refer around Bear handle both the carpentry and the paperwork.
Every contractor we connect you with runs an independent local business that carries its own license and insurance. Ask to see the insurance certificate before work starts, and any solid contractor will hand it over.
You get a written estimate itemized down to square feet of board, linear feet of base and shoe, and labor hours. Many write it in the line-item style adjusters already use, which cuts the back and forth on the claim.
A rebuild is rarely a 2 a.m. emergency, but waiting weeks for a bid stalls the whole claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Bear.
The restoration side runs on texture sprayers, taping knives, miter saws and profile gauges, not fans. That gear and some patience are what make a patched wall look like it was never cut.
The work follows the scope of loss, which lists each material removed during the dry-out that now has to be replaced.
Flood cuts get closed with new board, then tape, three coats of mud and sanding. The real skill is the texture, getting orange peel or knockdown to disappear into the original wall.
Wet MDF baseboard swells and never shrinks back, so it is replaced with a matching profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
Laminate and LVP tend to get replaced since water sits below the click joints and the core swells. Solid hardwood that was dried quickly can often be refinished, while engineered flooring is far less forgiving.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Repainting full walls to the corners avoids the shiny halo you get from spot painting.
Contents can be boxed, listed and stored off-site so the crew has open rooms to work in. The itemized list doubles as proof for the contents portion of the claim.
The contractor keeps the scope, progress photos, drying records and invoices together in a single file. Adjusters move faster when the paperwork answers their questions before they ask them.
The first half of any water loss is mitigation: stop the source, pull the water, remove what will not dry and run dehumidifiers until the meter says done. What comes after is restoration, and the work looks a lot more like a remodel than an emergency call.
Picture a dishwasher supply line that seeped under the cabinets for days before anyone saw it. The dry-out crew pulls the toe-kicks, drills or opens the cabinet bases and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.
The process has four steps, and the first is a short phone call.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We connect you with an independent rebuild contractor who works in Bear and confirm a walkthrough time.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
The written quote lists each line: board by the square foot, base by the linear foot, flooring, paint and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
At the end you walk every room with the contractor and write down anything that does not look right. Nothing gets signed until the punch list is done, and any workmanship warranty should be on paper.
Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Our kids clogged the upstairs toilet, it overflowed, and the kitchen ceiling ended up with a hole the size of a door. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I was sure the oak floor in our hallway was a total loss. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. It looks better than it did before the leak.
My rental had three rooms stripped to the studs and a tenant asking every day when it would be done. The local contractor I was connected with wrote a scope the adjuster barely changed, and the trim and paint matched the untouched rooms.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation stops the damage from spreading: extraction, tear-out of wet materials, antimicrobial treatment and drying to dry standard. Restoration puts the house back: drywall, texture, trim, flooring, cabinets and paint.
Insurance usually treats them as two parts of the same claim, often with two separate estimates.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Ask your contractor for a written schedule with the order of trades.
Generally you can. Your carrier may recommend a preferred vendor, but most policies let you hire the contractor you pick. Read your policy and confirm with your adjuster before signing anything.
Many contractors in our network work directly with adjusters and write estimates in the format insurers expect.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. The contractor checks readings over several days before deciding to sand and refinish.
Engineered flooring and boards that crowned, split or buckled usually need replacing.
They should, if the contractor matches the texture on a test piece and repaints full walls instead of spot painting. The paint is matched from a chip cut out of the original wall, not from an old can label.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The contractors we refer live and work in the area, so they know the local housing stock and the local permit office.
Older homes near downtown Bear tend to have plaster walls and solid wood trim that take extra care to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.
Tell us what came out and we will connect you with a local contractor.
Call +1-877-637-9008