Licensed and Insured Independent Pros
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
Once the drying gear is hauled out, most homes are left with open walls, bare subfloor and missing trim. Putting it back is restoration, and it is a different job from the cleanup.
Our referral line links Pulaski homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. Every job starts with an itemized written scope you can hand straight to your adjuster.

Restoration is drywall, trim and flooring work done on a house that just got soaked. The contractors we refer around Pulaski handle both the carpentry and the paperwork.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
You get a written estimate itemized down to square feet of board, linear feet of base and shoe, and labor hours. Many contractors use the same line-item format adjusters work in, so the claim review moves faster.
A rebuild is rarely a 2 a.m. emergency, but waiting weeks for a bid stalls the whole claim. Our dispatchers confirm a real walkthrough time on the call with a contractor who works near Pulaski.
The restoration side runs on texture sprayers, taping knives, miter saws and profile gauges, not fans. That gear and some patience are what make a patched wall look like it was never cut.
Each job follows the scope of loss: a written list of every material that came out during mitigation and has to go back in.

Flood cuts get closed with new board, then tape, three coats of mud and sanding. The hard part is texture: orange peel, knockdown and skip trowel all have to blend into the wall that stayed.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
Laminate and LVP tend to get replaced since water sits below the click joints and the core swells. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Good contractors repaint the affected walls corner to corner, so there is no halo around the repair.
Furniture, boxes and electronics can be photographed, inventoried, packed out and stored while the rebuild runs. The itemized list doubles as proof for the contents portion of the claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. Adjusters move faster when the paperwork answers their questions before they ask them.
The first half of any water loss is mitigation: stop the source, pull the water, remove what will not dry and run dehumidifiers until the meter says done. What comes after is restoration, and the work looks a lot more like a remodel than an emergency call.
Picture a dishwasher supply line that seeped under the cabinets for days before anyone saw it. Mitigation pulls the toe-kicks, opens the cabinet bases for airflow and dries the subfloor. Restoration is the part where someone finds a matching toe-kick, replaces the swollen sink base and ties new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.

The process has four steps, and the first is a short phone call.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors send it straight to your adjuster and write a supplement if hidden damage turns up.
At the end you walk every room with the contractor and write down anything that does not look right. Nothing gets signed until the punch list is done, and any workmanship warranty should be on paper.

Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Upstairs toilet overflowed and a big chunk of the kitchen ceiling had to be cut out a week before the holidays. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I was sure the oak floor in our hallway was a total loss. The contractor took readings, confirmed it was solid hardwood that had dried out, and sanded and refinished it instead of tearing it out. It looks better than it did before the leak.
My rental had three rooms stripped to the studs and a tenant asking every day when it would be done. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
Call now and a dispatcher will connect you with an independent rebuild contractor near Pulaski.
Mitigation stops the damage from spreading: extraction, tear-out of wet materials, antimicrobial treatment and drying to dry standard. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Get a written schedule from the contractor that shows which trade comes when.
In most cases yes. Insurers may suggest a preferred vendor, but the homeowner usually gets to choose who works on the house. Check your own policy and confirm with your adjuster before you sign a contract.
Many contractors in our network work directly with adjusters and write estimates in the format insurers expect.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Engineered flooring and boards that crowned, split or buckled usually need replacing.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. The paint is matched from a chip cut out of the original wall, not from an old can label.
Ask to see the texture sample before it goes on the wall, and walk the room in daylight before sign-off.
The contractors we refer live and work in the area, so they know the local housing stock and the local permit office.
Older houses close to downtown Pulaski often have plaster and real wood trim, which take more work to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.

Describe the open walls and we will route your call to a local pro.
Call +1-877-637-9008