Licensed and Insured Independent Pros
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
After mitigation wraps up, the house usually looks worse than it did on the day the leak started. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Marfa homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. Every job starts with an itemized written scope you can hand straight to your adjuster.

A rebuild after water damage is finish carpentry with an insurance file attached. The contractors we refer around Marfa handle both the carpentry and the paperwork.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many contractors use the same line-item format adjusters work in, so the claim review moves faster.
Restoration is not usually a midnight job, yet a slow bid can hold up your entire claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Marfa.
Rebuild crews carry texture hoppers, knockdown knives, trim saws and coping saws, not air movers. That gear and some patience are what make a patched wall look like it was never cut.
Each job follows the scope of loss: a written list of every material that came out during mitigation and has to go back in.

New drywall goes in above the flood cut, followed by tape, mud in three coats and a final sand. The hard part is texture: orange peel, knockdown and skip trowel all have to blend into the wall that stayed.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Repainting full walls to the corners avoids the shiny halo you get from spot painting.
Contents can be boxed, listed and stored off-site so the crew has open rooms to work in. That inventory also backs up the contents side of your insurance claim.
The contractor keeps the scope, progress photos, drying records and invoices together in a single file. Adjusters move faster when the paperwork answers their questions before they ask them.
The first half of any water loss is mitigation: stop the source, pull the water, remove what will not dry and run dehumidifiers until the meter says done. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Take a dishwasher supply line that dripped under the cabinets for days before anyone noticed. Mitigation pulls the toe-kicks, opens the cabinet bases for airflow and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or think about an upstairs toilet that overflowed and rained down through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.

The process has four steps, and the first is a short phone call.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
The contractor walks each room with a moisture meter to confirm the structure is truly dry before quoting.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors send it straight to your adjuster and write a supplement if hidden damage turns up.
When the last coat of paint is dry, you walk the house with the contractor and build a punch list. Sign off only after the punch list is cleared, and ask for any workmanship warranty in writing.

Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Upstairs toilet overflowed and a big chunk of the kitchen ceiling had to be cut out a week before the holidays. The contractor I was connected with hung new board, matched the knockdown and painted the whole ceiling. I honestly cannot find the patch.
I was sure the oak floor in our hallway was a total loss. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. Honestly the floor looks better now than before the leak.
I own a duplex and the tenant was living out of two rooms while the rest sat gutted. The local contractor I was connected with wrote a scope the adjuster barely changed, and the trim and paint matched the untouched rooms.
Call now and a dispatcher will connect you with an independent rebuild contractor near Marfa.
Mitigation stops the damage from spreading: extraction, tear-out of wet materials, antimicrobial treatment and drying to dry standard. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Ask your contractor for a written schedule with the order of trades.
In most cases yes. Insurers may suggest a preferred vendor, but the homeowner usually gets to choose who works on the house. Check your own policy and confirm with your adjuster before you sign a contract.
A lot of the independent contractors we refer deal with adjusters every week and write estimates the way carriers like them.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. The contractor checks readings over several days before deciding to sand and refinish.
Boards that have crowned, split or lifted, and most engineered planks, usually have to be replaced.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. Paint is matched from a chip of the existing wall, not from a guess at the color name.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The independent pros in our network are local, which means they know the houses around Marfa and how the permit desk works.
Older houses close to downtown Marfa often have plaster and real wood trim, which take more work to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.

Tell us what came out and we will connect you with a local contractor.
Call +1-877-637-9008