The water is gone and the fans have been picked up, but the kitchen still has a two-foot flood cut and no baseboards. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Ingram homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. Every job starts with an itemized written scope you can hand straight to your adjuster.
A rebuild after water damage is finish carpentry with an insurance file attached. The independent pros in our network do that kind of work every week in Ingram.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask to see the insurance certificate before work starts, and any solid contractor will hand it over.
You get a written estimate itemized down to square feet of board, linear feet of base and shoe, and labor hours. Many write it in the line-item style adjusters already use, which cuts the back and forth on the claim.
Restoration is not usually a midnight job, yet a slow bid can hold up your entire claim. Our dispatchers confirm a real walkthrough time on the call with a contractor who works near Ingram.
The restoration side runs on texture sprayers, taping knives, miter saws and profile gauges, not fans. That gear and some patience are what make a patched wall look like it was never cut.
Each job follows the scope of loss: a written list of every material that came out during mitigation and has to go back in.
New drywall goes in above the flood cut, followed by tape, mud in three coats and a final sand. The real skill is the texture, getting orange peel or knockdown to disappear into the original wall.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood that was dried quickly can often be refinished, while engineered flooring is far less forgiving.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Good contractors repaint the affected walls corner to corner, so there is no halo around the repair.
Contents can be boxed, listed and stored off-site so the crew has open rooms to work in. The itemized list doubles as proof for the contents portion of the claim.
The contractor keeps the scope, progress photos, drying records and invoices together in a single file. Adjusters move faster when the paperwork answers their questions before they ask them.
Mitigation is the emergency half: stop the water, extract it, tear out what cannot be dried and run equipment until the readings hit dry standard. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Take a dishwasher supply line that dripped under the cabinets for days before anyone noticed. The dry-out crew pulls the toe-kicks, drills or opens the cabinet bases and dries the subfloor. Restoration is the part where someone finds a matching toe-kick, replaces the swollen sink base and ties new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. After the wet ceiling drywall is cut out and the joists dry, someone still has to hang board overhead, match the texture and paint the full ceiling plane.
The crews that are great at fast tear-out are not always the ones you want doing finish work in your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.
Four steps, and the first one takes about five minutes on the phone.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
The contractor walks each room with a moisture meter to confirm the structure is truly dry before quoting.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
At the end you walk every room with the contractor and write down anything that does not look right. Nothing gets signed until the punch list is done, and any workmanship warranty should be on paper.
The dishwasher line had been leaking for who knows how long. The dry-out company left us with no toe-kicks and a sink base that looked like a sponge. The referral line put me in touch with a local contractor who matched the cabinet toe-kicks and talked to our adjuster so I was not stuck in the middle.
Upstairs toilet overflowed and a big chunk of the kitchen ceiling had to be cut out a week before the holidays. The contractor I was connected with hung new board, matched the knockdown and painted the whole ceiling. I honestly cannot find the patch.
I was sure the oak floor in our hallway was a total loss. The contractor took readings, confirmed it was solid hardwood that had dried out, and sanded and refinished it instead of tearing it out. Honestly the floor looks better now than before the leak.
My rental had three rooms stripped to the studs and a tenant asking every day when it would be done. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Get a written schedule from the contractor that shows which trade comes when.
Generally you can. Your carrier may recommend a preferred vendor, but most policies let you hire the contractor you pick. Check your own policy and confirm with your adjuster before you sign a contract.
A lot of the independent contractors we refer deal with adjusters every week and write estimates the way carriers like them.
Often, if they are solid hardwood and were dried quickly. Mild cupping can settle once the moisture content comes back to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Engineered flooring and boards that crowned, split or buckled usually need replacing.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. The paint is matched from a chip cut out of the original wall, not from an old can label.
Ask to see the texture sample before it goes on the wall, and walk the room in daylight before sign-off.
The independent pros in our network are local, which means they know the houses around Ingram and how the permit desk works.
Older houses close to downtown Ingram often have plaster and real wood trim, which take more work to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.
Tell us what came out and we will connect you with a local contractor.
Call +1-877-637-9008