Licensed and Insured Independent Pros
Every contractor we connect you with runs an independent local business that carries its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
After mitigation wraps up, the house usually looks worse than it did on the day the leak started. Putting it back is restoration, and it is a different job from the cleanup.
Our referral line links Phoenix homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. Every job starts with an itemized written scope you can hand straight to your adjuster.

Restoration is drywall, trim and flooring work done on a house that just got soaked. The contractors we refer around Phoenix handle both the carpentry and the paperwork.
Every contractor we connect you with runs an independent local business that carries its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many write it in the line-item style adjusters already use, which cuts the back and forth on the claim.
A rebuild is rarely a 2 a.m. emergency, but waiting weeks for a bid stalls the whole claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Phoenix.
The restoration side runs on texture sprayers, taping knives, miter saws and profile gauges, not fans. That kit, plus a steady hand, is what keeps a repaired wall from looking patched.
The work follows the scope of loss, which lists each material removed during the dry-out that now has to be replaced.

New drywall goes in above the flood cut, followed by tape, mud in three coats and a final sand. The real skill is the texture, getting orange peel or knockdown to disappear into the original wall.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. After a kitchen leak, toe-kicks and sometimes the whole sink base cabinet need replacing too.
Laminate and LVP tend to get replaced since water sits below the click joints and the core swells. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
The crew cuts a small chip from a dry wall and has the paint store scan it for a match. Good contractors repaint the affected walls corner to corner, so there is no halo around the repair.
Furniture, boxes and electronics can be photographed, inventoried, packed out and stored while the rebuild runs. That inventory also backs up the contents side of your insurance claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. Adjusters move faster when the paperwork answers their questions before they ask them.
Mitigation is the emergency half: stop the water, extract it, tear out what cannot be dried and run equipment until the readings hit dry standard. What comes after is restoration, and the work looks a lot more like a remodel than an emergency call.
Picture a dishwasher supply line that seeped under the cabinets for days before anyone saw it. Mitigation pulls the toe-kicks, opens the cabinet bases for airflow and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. After the wet ceiling drywall is cut out and the joists dry, someone still has to hang board overhead, match the texture and paint the full ceiling plane.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.

The process has four steps, and the first is a short phone call.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
The contractor walks each room with a moisture meter to confirm the structure is truly dry before quoting.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
At the end you walk every room with the contractor and write down anything that does not look right. Nothing gets signed until the punch list is done, and any workmanship warranty should be on paper.

The dishwasher line had been leaking for who knows how long. The dry-out company left us with no toe-kicks and a sink base that looked like a sponge. The referral line put me in touch with a local contractor who matched the cabinet toe-kicks and talked to our adjuster so I was not stuck in the middle.
Upstairs toilet overflowed and a big chunk of the kitchen ceiling had to be cut out a week before the holidays. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I was sure the oak floor in our hallway was a total loss. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. Honestly the floor looks better now than before the leak.
I own a duplex and the tenant was living out of two rooms while the rest sat gutted. The local contractor I was connected with wrote a scope the adjuster barely changed, and the trim and paint matched the untouched rooms.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration puts the house back: drywall, texture, trim, flooring, cabinets and paint.
Insurance usually treats them as two parts of the same claim, often with two separate estimates.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Get a written schedule from the contractor that shows which trade comes when.
In most cases yes. Insurers may suggest a preferred vendor, but the homeowner usually gets to choose who works on the house. Check your own policy and confirm with your adjuster before you sign a contract.
Many contractors in our network work directly with adjusters and write estimates in the format insurers expect.
Often, if they are solid hardwood and were dried quickly. Mild cupping can settle once the moisture content comes back to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Engineered flooring and boards that crowned, split or buckled usually need replacing.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. The paint is matched from a chip cut out of the original wall, not from an old can label.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The independent pros in our network are local, which means they know the houses around Phoenix and how the permit desk works.
Older homes near downtown Phoenix tend to have plaster walls and solid wood trim that take extra care to match. Newer subdivisions mean builder-grade drywall, MDF base and LVP that are easier to source but quick to swell.

Describe the open walls and we will route your call to a local pro.
Call +1-877-637-9008