Licensed and Insured Independent Pros
Every contractor we connect you with runs an independent local business that carries its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
Once the drying gear is hauled out, most homes are left with open walls, bare subfloor and missing trim. Rebuilding all of that is restoration, which is its own trade with its own crews.
One call to Doral Water Damage puts you in touch with an independent, licensed and insured rebuild contractor working in Union. Every job starts with an itemized written scope you can hand straight to your adjuster.

Restoration is drywall, trim and flooring work done on a house that just got soaked. The contractors we refer around Union handle both the carpentry and the paperwork.
Every contractor we connect you with runs an independent local business that carries its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many write it in the line-item style adjusters already use, which cuts the back and forth on the claim.
Restoration is not usually a midnight job, yet a slow bid can hold up your entire claim. Our dispatchers confirm a real walkthrough time on the call with a contractor who works near Union.
The restoration side runs on texture sprayers, taping knives, miter saws and profile gauges, not fans. That kit, plus a steady hand, is what keeps a repaired wall from looking patched.
The work follows the scope of loss, which lists each material removed during the dry-out that now has to be replaced.

New drywall goes in above the flood cut, followed by tape, mud in three coats and a final sand. The hard part is texture: orange peel, knockdown and skip trowel all have to blend into the wall that stayed.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. After a kitchen leak, toe-kicks and sometimes the whole sink base cabinet need replacing too.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Repainting full walls to the corners avoids the shiny halo you get from spot painting.
Furniture, boxes and electronics can be photographed, inventoried, packed out and stored while the rebuild runs. That inventory also backs up the contents side of your insurance claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. Adjusters move faster when the paperwork answers their questions before they ask them.
The first half of any water loss is mitigation: stop the source, pull the water, remove what will not dry and run dehumidifiers until the meter says done. What comes after is restoration, and the work looks a lot more like a remodel than an emergency call.
Take a dishwasher supply line that dripped under the cabinets for days before anyone noticed. The dry-out crew pulls the toe-kicks, drills or opens the cabinet bases and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or think about an upstairs toilet that overflowed and rained down through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
The crews that are great at fast tear-out are not always the ones you want doing finish work in your living room.
Plenty of companies only do the dry-out. Ask any contractor directly whether the rebuild is included, and make sure the answer is in the written scope.

Four steps, and the first one takes about five minutes on the phone.
Tell the dispatcher what was removed during mitigation and whether you have an open claim. We connect you with an independent rebuild contractor who works in Union and confirm a walkthrough time.
The contractor walks each room with a moisture meter to confirm the structure is truly dry before quoting.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
At the end you walk every room with the contractor and write down anything that does not look right. Sign off only after the punch list is cleared, and ask for any workmanship warranty in writing.

The dishwasher line had been leaking for who knows how long. The dry-out company left us with no toe-kicks and a sink base that looked like a sponge. The referral line put me in touch with a local contractor who matched the cabinet toe-kicks and talked to our adjuster so I was not stuck in the middle.
Our kids clogged the upstairs toilet, it overflowed, and the kitchen ceiling ended up with a hole the size of a door. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I was sure the oak floor in our hallway was a total loss. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. Honestly the floor looks better now than before the leak.
I own a duplex and the tenant was living out of two rooms while the rest sat gutted. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
It depends on the scope. A single room of drywall and paint can be done in days, while a kitchen with cabinets and new flooring can run several weeks. The delays usually come from backordered materials and claim approvals rather than the actual work.
Get a written schedule from the contractor that shows which trade comes when.
In most cases yes. Insurers may suggest a preferred vendor, but the homeowner usually gets to choose who works on the house. Check your own policy and confirm with your adjuster before you sign a contract.
Many contractors in our network work directly with adjusters and write estimates in the format insurers expect.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Boards that have crowned, split or lifted, and most engineered planks, usually have to be replaced.
They should, if the contractor matches the texture on a test piece and repaints full walls instead of spot painting. The paint is matched from a chip cut out of the original wall, not from an old can label.
Ask to see the texture sample before it goes on the wall, and walk the room in daylight before sign-off.
The independent pros in our network are local, which means they know the houses around Union and how the permit desk works.
Older houses close to downtown Union often have plaster and real wood trim, which take more work to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.

Describe the open walls and we will route your call to a local pro.
Call +1-877-637-9008