Licensed and Insured Independent Pros
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The water is gone and the fans have been picked up, but the kitchen still has a two-foot flood cut and no baseboards. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Plainview homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. You get a written, line-itemed scope before anyone picks up a hammer.

A rebuild after water damage is finish carpentry with an insurance file attached. The contractors we refer around Plainview handle both the carpentry and the paperwork.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many contractors use the same line-item format adjusters work in, so the claim review moves faster.
A rebuild is rarely a 2 a.m. emergency, but waiting weeks for a bid stalls the whole claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Plainview.
The restoration side runs on texture sprayers, taping knives, miter saws and profile gauges, not fans. That gear and some patience are what make a patched wall look like it was never cut.
The work follows the scope of loss, which lists each material removed during the dry-out that now has to be replaced.

New drywall goes in above the flood cut, followed by tape, mud in three coats and a final sand. The real skill is the texture, getting orange peel or knockdown to disappear into the original wall.
Wet MDF baseboard swells and never shrinks back, so it is replaced with a matching profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
The crew cuts a small chip from a dry wall and has the paint store scan it for a match. Repainting full walls to the corners avoids the shiny halo you get from spot painting.
Furniture, boxes and electronics can be photographed, inventoried, packed out and stored while the rebuild runs. That inventory also backs up the contents side of your insurance claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. A complete file usually means fewer re-inspections and fewer arguments over supplements.
The first half of any water loss is mitigation: stop the source, pull the water, remove what will not dry and run dehumidifiers until the meter says done. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Picture a dishwasher supply line that seeped under the cabinets for days before anyone saw it. Mitigation pulls the toe-kicks, opens the cabinet bases for airflow and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.

Four steps, and the first one takes about five minutes on the phone.
Tell the dispatcher what was removed during mitigation and whether you have an open claim. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors send it straight to your adjuster and write a supplement if hidden damage turns up.
At the end you walk every room with the contractor and write down anything that does not look right. Nothing gets signed until the punch list is done, and any workmanship warranty should be on paper.

Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Upstairs toilet overflowed and a big chunk of the kitchen ceiling had to be cut out a week before the holidays. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I figured the hallway oak was headed for the dumpster. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. It looks better than it did before the leak.
I own a duplex and the tenant was living out of two rooms while the rest sat gutted. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration puts the house back: drywall, texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
It depends on the scope. A single room of drywall and paint can be done in days, while a kitchen with cabinets and new flooring can run several weeks. The delays usually come from backordered materials and claim approvals rather than the actual work.
Ask your contractor for a written schedule with the order of trades.
In most cases yes. Insurers may suggest a preferred vendor, but the homeowner usually gets to choose who works on the house. Check your own policy and confirm with your adjuster before you sign a contract.
A lot of the independent contractors we refer deal with adjusters every week and write estimates the way carriers like them.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Boards that have crowned, split or lifted, and most engineered planks, usually have to be replaced.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. Paint is matched from a chip of the existing wall, not from a guess at the color name.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The independent pros in our network are local, which means they know the houses around Plainview and how the permit desk works.
Older houses close to downtown Plainview often have plaster and real wood trim, which take more work to match. Newer subdivisions mean builder-grade drywall, MDF base and LVP that are easier to source but quick to swell.

Tell us what came out and we will connect you with a local contractor.
Call +1-877-637-9008