The water is gone and the fans have been picked up, but the kitchen still has a two-foot flood cut and no baseboards. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Gillespie homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. You get a written, line-itemed scope before anyone picks up a hammer.
Restoration is drywall, trim and flooring work done on a house that just got soaked. The independent pros in our network do that kind of work every week in Gillespie.
Every contractor we connect you with runs an independent local business that carries its own license and insurance. Ask to see the insurance certificate before work starts, and any solid contractor will hand it over.
You get a written estimate itemized down to square feet of board, linear feet of base and shoe, and labor hours. Many write it in the line-item style adjusters already use, which cuts the back and forth on the claim.
Restoration is not usually a midnight job, yet a slow bid can hold up your entire claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Gillespie.
The restoration side runs on texture sprayers, taping knives, miter saws and profile gauges, not fans. That gear and some patience are what make a patched wall look like it was never cut.
Each job follows the scope of loss: a written list of every material that came out during mitigation and has to go back in.
Flood cuts get closed with new board, then tape, three coats of mud and sanding. The real skill is the texture, getting orange peel or knockdown to disappear into the original wall.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Repainting full walls to the corners avoids the shiny halo you get from spot painting.
Contents can be boxed, listed and stored off-site so the crew has open rooms to work in. That inventory also backs up the contents side of your insurance claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. Adjusters move faster when the paperwork answers their questions before they ask them.
Mitigation is the emergency half: stop the water, extract it, tear out what cannot be dried and run equipment until the readings hit dry standard. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Picture a dishwasher supply line that seeped under the cabinets for days before anyone saw it. The dry-out crew pulls the toe-kicks, drills or opens the cabinet bases and dries the subfloor. Restoration is the part where someone finds a matching toe-kick, replaces the swollen sink base and ties new flooring into the old at the doorway.
Or think about an upstairs toilet that overflowed and rained down through the kitchen ceiling. After the wet ceiling drywall is cut out and the joists dry, someone still has to hang board overhead, match the texture and paint the full ceiling plane.
The crews that are great at fast tear-out are not always the ones you want doing finish work in your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.
The process has four steps, and the first is a short phone call.
Tell the dispatcher what was removed during mitigation and whether you have an open claim. We connect you with an independent rebuild contractor who works in Gillespie and confirm a walkthrough time.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
The written quote lists each line: board by the square foot, base by the linear foot, flooring, paint and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
At the end you walk every room with the contractor and write down anything that does not look right. Nothing gets signed until the punch list is done, and any workmanship warranty should be on paper.
Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Our kids clogged the upstairs toilet, it overflowed, and the kitchen ceiling ended up with a hole the size of a door. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I figured the hallway oak was headed for the dumpster. The contractor took readings, confirmed it was solid hardwood that had dried out, and sanded and refinished it instead of tearing it out. Honestly the floor looks better now than before the leak.
My rental had three rooms stripped to the studs and a tenant asking every day when it would be done. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation stops the damage from spreading: extraction, tear-out of wet materials, antimicrobial treatment and drying to dry standard. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. The delays usually come from backordered materials and claim approvals rather than the actual work.
Get a written schedule from the contractor that shows which trade comes when.
Generally you can. Your carrier may recommend a preferred vendor, but most policies let you hire the contractor you pick. Check your own policy and confirm with your adjuster before you sign a contract.
A lot of the independent contractors we refer deal with adjusters every week and write estimates the way carriers like them.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. The contractor checks readings over several days before deciding to sand and refinish.
Boards that have crowned, split or lifted, and most engineered planks, usually have to be replaced.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. Paint is matched from a chip of the existing wall, not from a guess at the color name.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The independent pros in our network are local, which means they know the houses around Gillespie and how the permit desk works.
Older houses close to downtown Gillespie often have plaster and real wood trim, which take more work to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.
Describe the open walls and we will route your call to a local pro.
Call +1-877-637-9008