After mitigation wraps up, the house usually looks worse than it did on the day the leak started. Putting it back is restoration, and it is a different job from the cleanup.
Our referral line links Boston homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. You get a written, line-itemed scope before anyone picks up a hammer.
A rebuild after water damage is finish carpentry with an insurance file attached. The contractors we refer around Boston handle both the carpentry and the paperwork.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask to see the insurance certificate before work starts, and any solid contractor will hand it over.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many contractors use the same line-item format adjusters work in, so the claim review moves faster.
Restoration is not usually a midnight job, yet a slow bid can hold up your entire claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Boston.
Rebuild crews carry texture hoppers, knockdown knives, trim saws and coping saws, not air movers. That kit, plus a steady hand, is what keeps a repaired wall from looking patched.
Each job follows the scope of loss: a written list of every material that came out during mitigation and has to go back in.
Flood cuts get closed with new board, then tape, three coats of mud and sanding. The hard part is texture: orange peel, knockdown and skip trowel all have to blend into the wall that stayed.
Wet MDF baseboard swells and never shrinks back, so it is replaced with a matching profile. Cabinet toe-kicks, and sometimes the sink base itself, get the same treatment after a kitchen leak.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood that was dried quickly can often be refinished, while engineered flooring is far less forgiving.
The crew cuts a small chip from a dry wall and has the paint store scan it for a match. Repainting full walls to the corners avoids the shiny halo you get from spot painting.
Furniture, boxes and electronics can be photographed, inventoried, packed out and stored while the rebuild runs. That inventory also backs up the contents side of your insurance claim.
The contractor keeps the scope, progress photos, drying records and invoices together in a single file. Adjusters move faster when the paperwork answers their questions before they ask them.
The first half of any water loss is mitigation: stop the source, pull the water, remove what will not dry and run dehumidifiers until the meter says done. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Picture a dishwasher supply line that seeped under the cabinets for days before anyone saw it. Mitigation pulls the toe-kicks, opens the cabinet bases for airflow and dries the subfloor. Restoration is the part where someone finds a matching toe-kick, replaces the swollen sink base and ties new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.
The process has four steps, and the first is a short phone call.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We connect you with an independent rebuild contractor who works in Boston and confirm a walkthrough time.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors send it straight to your adjuster and write a supplement if hidden damage turns up.
When the last coat of paint is dry, you walk the house with the contractor and build a punch list. Nothing gets signed until the punch list is done, and any workmanship warranty should be on paper.
The dishwasher line had been leaking for who knows how long. The dry-out company left us with no toe-kicks and a sink base that looked like a sponge. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Our kids clogged the upstairs toilet, it overflowed, and the kitchen ceiling ended up with a hole the size of a door. The contractor I was connected with hung new board, matched the knockdown and painted the whole ceiling. I honestly cannot find the patch.
I figured the hallway oak was headed for the dumpster. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. Honestly the floor looks better now than before the leak.
I own a duplex and the tenant was living out of two rooms while the rest sat gutted. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Get a written schedule from the contractor that shows which trade comes when.
Generally you can. Your carrier may recommend a preferred vendor, but most policies let you hire the contractor you pick. Read your policy and confirm with your adjuster before signing anything.
Many contractors in our network work directly with adjusters and write estimates in the format insurers expect.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Engineered flooring and boards that crowned, split or buckled usually need replacing.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. Paint is matched from a chip of the existing wall, not from a guess at the color name.
Ask to see the texture sample before it goes on the wall, and walk the room in daylight before sign-off.
The contractors we refer live and work in the area, so they know the local housing stock and the local permit office.
Older houses close to downtown Boston often have plaster and real wood trim, which take more work to match. Newer subdivisions mean builder-grade drywall, MDF base and LVP that are easier to source but quick to swell.
Describe the open walls and we will route your call to a local pro.
Call +1-877-637-9008